Rotary knob for Grundig TS1000
Optically and functionally matching spare part for Grundig TS1000 rotary knobs.
- Replaces defective or broken knobs on the Grundig TS1000.
- High-quality 3D print based on CAD redesign including brushed aluminum inserts.
- Put the knob on the axle like the original.
- Look and function like the original.
- 1x knob for Grundig TS1000
- worldwide shipping from €7.45
- Budget Shipping just 2,95 € (domestic Germany)
- One month right of withdrawal
SKU: 10029
Over time, the filigree plastic of the Grundig TS1000 slider hardens and the fine driver pins break off.
The sleeve breaks off at the rotary knobs and ultimately the TS1000 has to endure a dull existence with "tooth gaps".
Another reason why the controls break off or get lost over time is when removing the front cover on the TS1000 - the sliders in particular can be damaged here, as they are built into the front panel.
The knobs and sliders offered here as DIY spare parts for the Grundig TS1000 are 3D printed (Multi Jet Fusion) 1:1 to match the original parts. Due to the tumbling that follows the 3D print, the spare parts have a handsome, slightly rough, non-slip surface structure.
The aluminum sheets glued to the original part can also be attached to these spare parts. To do this, stick the existing aluminum sheet of the defective original parts onto the spare part. If there is no original leaflet, you can also paint the spare part in an aluminum look to keep the original look.
The sleeve breaks off at the rotary knobs and ultimately the TS1000 has to endure a dull existence with "tooth gaps".
Another reason why the controls break off or get lost over time is when removing the front cover on the TS1000 - the sliders in particular can be damaged here, as they are built into the front panel.
The knobs and sliders offered here as DIY spare parts for the Grundig TS1000 are 3D printed (Multi Jet Fusion) 1:1 to match the original parts. Due to the tumbling that follows the 3D print, the spare parts have a handsome, slightly rough, non-slip surface structure.
The aluminum sheets glued to the original part can also be attached to these spare parts. To do this, stick the existing aluminum sheet of the defective original parts onto the spare part. If there is no original leaflet, you can also paint the spare part in an aluminum look to keep the original look.